5
Congratulations on purchasing a Full Boar Bandsaw.
Your Full Boar Bandsaw FBT-2450 has been designed for
cutting wood and wood composition products. It can be
used for curve cuts and straight line cutting operations like
cross cutting, ripping, bevelling and compound cutting.
Warning!
When using mains-powered equipment, basic safety precautions,
including the following, should always be followed to reduce risk of fire, electric
shock, personal injury and material damage.
Read and understand the manual prior to operating this tool.
Save these instructions and other documents supplied with this tool for future reference.
The electric motor has been designed for 230V and 240V only. Always check that the power
supply corresponds to the voltage on the rating plate.
Note:
The supply of 230V and 240V on Full Boar tools are interchangeable for Australia and
New Zealand.
The supply cord assessed as type Y attached by using AS/NZS 60335.1. For appliances with
type Y attachment
, the instructions shall contain the substance of the following
If the supply cord is damaged, it must be replaced by an electrician or a power tool repairer
in order to avoid a hazard.
Using an Extension Lead
Always use an approved extension lead suitable for the power input of this tool. Before use,
inspect the extension lead for signs of damage, wear and ageing. Replace the extension
lead if damaged or defective. When using an extension lead on a reel, always unwind the
lead completely. Use of an extension lead not suitable for the power input of the tool or
which is damaged or defective may result in a risk of fire and electric shock.
!
ELECTRICAL SAFETY
SAFETY INSTRUCTIONS
INTRODUCTION
