12
ASSEMBLY (cont.)
WARNING!
Prior to assembly, ensure you switch the machine off and disconnect
it from the power supply.
Small dust port (Fig.12):
1.
Assemble the small dust port (7) over with the grate by
first removing the 4 screws and washer from the grate
and reattaching with the small dust port (7).
Note:
The grate is a safety feature and should never be
removed from the bandsaw.
Assembling of saw table (19):
1.
Remove plastic wing nut on underside of the saw table
(19) (Fig 13).
2.
Lead the blade (5) through the slot in the saw table (19)
(Fig 14). Place the saw table (19) on the table guide so
that the clamping screw fits through the mounting.
3.
Screw the saw table (19) tight with the plastic wing nut
(Fig 15).
4.
Place the fence guide on the saw table (19) so the screw
heads slide into the guide slots (Fig 16). Secure the fence
guide tight with the plastic knobs on the underside of
saw table (19).
5.
Manually check that the blade (5) runs freely and does
not touch the saw table (19) (Fig 17).
Fig.13
Fig.14
Fig.15
Fig.16
Fig.17
Fig.12
!
