increases the head's rotational speed in 4 steps up to a maximum speed of
1,000rpm.
For Interior work, we suggest using slower speeds, where the laser beam is
easier to see by eye; but for Exterior Groundworks – run the FRE-102AG at
its maximum speed of 1,000rpm, which gives the best working range when
used with the supplied Laser Detector. Even with its intensely bright green
beam, the detector will still be required for most outdoor work.
SCAN function - for Interior setting-out:
The top button on the left of the keypad is the Scan function. The User can
set a static dot, 10, 45, 90, 180 degree lines as required & use the two
buttons beneath (marked with rotational arrows) to move these lines around
the room.
AS THIS LASER AUTO LEVELS BOTH HORIZONTALLY & VERTICALLY,
all the control settings above operate in either mode.
(Vertical leveling,
with the laser positioned on its side, is often refered to as
"
Laydown
";
where
the User can project vertical laser lines or for setting-out: Site SQUARING (90
deg).
Grading:
This is a
DUAL GRADE
facility laser level. This means that the FRE-102AG
can be switched to "Manual" to over-ride the level sensors (via the auto/man
button) and then the User can set a grade (incline/slope) in the X axis only, Y
axis only or both together. The max. settable slope is an approx. fall of 1m
over 10m.
For X & Y alignment, please see the case markings on the TOP of the laser
body, where an arrow points in the direction of the axis being set.
Setting a single axis slope
-
This sets a grade in the X axis.
Procedure – switch ON; the FRE-102AG then auto levels. Press the
"auto/man" button on laser's keypad (bottom left hand side) & the green "X"
LED illuminates. Using the up & down Arrow buttons, set the % slope (fall)
required - as measured on your staff. The same buttons can be found on the
Remote Control.
To return to Auto level, switch the Manual button to OFF (both LEDs turn off).
The Laser will wait to find true level, then automatically restart, self-leveled.
3
