Fujitsu SPARC Enterprise T2000, Руководство по установке, Страница: 55 / 88

Chapter 2 Installing the Server 29
Note – This port is not operational until you configure the network settings
(through the serial managment port), as detailed in “To Configure the System
Controller Network Management Port” on page 39 .
Note –
The SC network management port is configured by default to retrieve
network settings via Dynamic Host Configuration Protocol (DHCP) and allow
connections using Solaris Secure Shell (SSH
®
). You might need to modify these
settings for your network. Instructions are given in Chapter 3 .
AC Power Cables
Note –
Finish the hardware procedures in this chapter, but do not attach the AC
power cables yet.
Powering on the system for the first time requires special preparation and
procedures. For example, if you have not prepared a display before connecting the
AC power cables, system messages may be lost. You will be instructed to connect the
server to AC power in
“Powering On the System for the First Time” on page 33 .
Caution – The server goes into standby mode and the system controller initializes
as soon as the AC power cables are connected to the power source.
TTYA Serial Port
The TTYA serial port connector uses a DB-9 connector (item 1 in
FIGURE 2-19
). Use
this port for general purpose serial data transfers. This port is not connected to the
SC serial management port.