Fujitsu SPARC ENTERPRISE T1000, Руководство по установке, Страница: 48 / 84

22 SPARC Enterprise T1000 Server Installation Guide • April 2007
▼
To Connect the SC Serial Management Port
The system controller serial management port is marked SER MGT (
FIGURE 2-10
).
FIGURE 2-10
System Controller Serial and Network Ports, Rear of Chassis
Note – Use the SC serial management port only for server management. It is the
default connection between the system controller and a terminal or a computer.
Caution – Do not attach a modem to this port.
●
Connect a Category 5 cable from the SER MGT serial management port to the
terminal device.
When connecting either a DB-9 or a DB-25 cable, use an adapter to perform the
crossovers given for each connector.
▼
To Connect the SC Network Management Port
The system controller network management port is marked NET MGT (
FIGURE 2-10
).
Note – The SC network management port is configured by default to retrieve
network settings via Dynamic Host Configuration Protocol (DHCP) and allow
connections using Solaris Secure Shell (SSH
®
). You might need to modify these
settings for your network. Instructions are given in Chapter 3 .
●
Connect a Category 5 cable from the NET MGT network management port to your
network switch or hub.
SER MGT NET MGT