Fujitsu PRIMERGY, Руководство пользователя

Страница: 45 / 56

15
E
4
Advanced Configuration Options
Do not change the Advanced Configuration settings unless absolutely necessary.
・ Reset SCSI Bus at IC Initialization
The SCSI bus that is produced during IC initialization after the system is
turned on or after the hardware is reset can be reset to ｢Enabled｣ or
｢Disabled｣ by this option. The default setting of this option is ｢Enabled｣.
・ Host Adapter BIOS (Configuration Utility Reserves BIOS space)
This option allows you to ｢Enabled｣ or ｢Disabled｣ Host Adapter BIOS. The
default setting is ｢Enabled｣.
Note
Some SCSISelect utility options are not ｢Enabled｣unless Host Adapter
BIOS is enabled. (Refer to the table of "
■
Default settings" appearing in
the chapter " 3.3 This Card Configuration (SCSI Select Utility), (1)
Configure/View Host Adapter Settings".)
When you boot the system from a SCSI device connected to this card, be sure
to ｢Enabled｣ Host Adapter BIOS. All peripherals on the SCSI bus are
controlled by the device driver. If you do not need Host Adapter BIOS,
｢Disabled｣ Host Adapter BIOS.
・ Support Removable Disks Under BIOS as Fixed Disks
Using this option allows you to control what removable-media drives this card
supports. The default setting is ｢Boot Only｣. This setting has the following
options:
− Boot Only
Only a removable-media drive specified as a boot device is considered a
hard disk drive.
− All Disks
All removable-media drives that Host Adapter BIOS supports are
considered hard disk drives.
− Disabled
No removable-media drives are considered hard disk drives. Since these
drives are not controlled in this situation, a software driver is required.