Fujitsu PRIMERGY TX150 S7, Руководство по эксплуатации

Страница: 43 / 120

TX150 S7
Operating Manual 43
Hardware installation Setting up the floorstand model
4.2 Setting up the floorstand model
I
If you are not installing a PRIMERGY TX150 S7 floorstand model, skip
this section and continue reading at section "Installing/removing the rack
model" on page 45 .
Ê
Transport the server to the place where you want to set it up.
Ê
Unpack the server (see section "Unpacking the server" ).
Ê
Set up the server.
I
Note that on floorstand models with hot-plug power supply units, for
safety reasons (risk of tipping) the anti-tilt bracket supplied must be
fitted on the rear of the server (see section
"Mounting the anti-tilt
bracket" on page 44 ).
V
CAUTION!
– The device must be protected from direct sunlight.
– The required minimum distances for operation and maintenance
areas must be adhered to.
– The server must be accessible at the rear for connection to other
devices (e.g. memory subsystem).
– The mains plug must be accessible easily and safely.
– There must be a clearance of at least 200 mm in front of and
behind the server to ensure adequate ventilation of the
subsystem.
Ê
Wire the server. Follow the instructions in sections "Connecting devices to
the server" on page 55 and "Notes on connecting/disconnecting cables" on
page 58 .
Ê
Connect the server to the mains (see section "Connecting the server to the
mains" on page 56 ).