56
• CLEAN LED
This turns on when cleaning is required.
• FAULT LED
This blinks when an unrecoverable error occurs and turns on when the internal temperature of the
drive exceeds the temperature conditions for installation.
The meaning of LED display
• LED display during Power-On Self-Test
When this device is turned on, LEDs change as indicated in the table below.
It takes about 30 seconds until the self diagnostic test completes and the device is available.
• LED display during use
*: CLEAN LED
When CLEAN LED turns on, it indicates cleaning is required.
CLEAN LED turns on in the following cases.
- When the device judges cleaning is required
- When a read error or write error occurs
`
When the FAULT LED and the ACTIVITY LED blink at the same time a media error
has occurred.Refer to " Troubleshooting" and perform recovery procedures.
Status
READY LED
(Green)
ACTIVITY
LED (Green)
CLEAN LED
(Amber)
FAULT LED
(Amber)
LED lighting test
ON
ON
ON
ON
Self diagnostic test
Blinking
OFF
ON/OFF*
OFF
OFF
Blinking
ON/OFF*
OFF
Ready
OFF
OFF
ON/OFF*
OFF
Status
READY LED
(Green)
ACTIVITY
LED (Green)
CLEAN LED
(Amber)
FAULT LED
(Amber)
No cartridge is loaded
OFF
OFF
ON/OFF*
OFF
Cartridge is loaded (Not
operating)
ON
OFF
ON/OFF*
OFF
Cartridge is loaded (Oper-
ating to write, read, etc.)
ON
Blinking
ON/OFF*
OFF
Cartridge is being loaded/
unloaded
OFF
Blinking
ON/OFF*
OFF
Cleaning required
ON/OFF
OFF/Blinking
ON
OFF
Cleaning
OFF
Blinking
ON
OFF
Unrecoverable error
ON/OFF
OFF
ON/OFF*
Blinking
Recommended operation
temperature
exceeded(Cartridge is
ejected)
OFF
OFF
ON/OFF*
ON
Media error
OFF
Blinking
ON/OFF*
Blinking
