BX924 S4
Upgrade and Maintenance Manual
97
6
Hard disk drives / Solid state
drives
Safety notes
V
CAUTION!
●
The drive must not be removed from the installation frame by anyone
except a service technician.
●
Drive modules must all be marked clearly so that they can be
reinstalled into their original mounting locations after an upgrade.
Otherwise, data may be lost.
●
Do not touch the circuitry on boards or soldered parts. Hold the
metallic areas or the edges of the circuit boards.
●
Depending on the OS, you can configure the write cache settings for
the drives. If a power failure should occur while the write cache is
enabled, cached data may be lost.
●
When disposing of, transferring, or returning a hard disk or solid state
drive, wipe out the data on the drive for your own security.
●
Rough handling of drives may damage the stored data. To cope with
any unexpected problems, always back up important data. When
backing up data to another hard disk drive, you should make backups
on a file or partition basis.
●
Do not use the device in extremely hot or cold locations, or locations
with extreme temperature changes.
●
Never attempt to disassemble a hard disk or solid state drive.
●
For further safety information, please refer to chapter
"Important
information" on page 29
.
6.1
Basic information
– One HDD or up to two SSDs are supported in BX924 S4.
– Hard disk drives / Solid state drives with different capacities are installed
from highest to lowest capacity.
– No mix of different bus technologies (SAS or SATA) is allowed.