Serial Asynchronous Flash Programming
Chapter 4 GALEP-Programmer
© Fujitsu Microelectronics Europe GmbH
- 33 -
MCU-AN-300012-E-V13
4.2.3 Serial Asynchronous Programming with GALEP-5 Programmer
For serial asynchronous programming also the ISP adapter is needed. Connect the starterkit
via serial cable to the DSBU9 connector on the ISP adapter. Do jumper settings on starterkit
as described in following chapters depending on your board type. Additionally set DTR
signal as reset signal.
Figure 31: Serial Asynchronous Programming with GALEP-5 Programmer
Start the GALEP5 programmer software and use ‘Load’ command to load a bin or hex file.
Select tab ‘Devices’ and browse to the correct device, e.g. MCU
Fujitsu
MB91F467D.
Choose ASYNC for serial asynchronous programming. Use ‘Select Device!’ button to accept
current selection.
Use the functions now enabled on the bottom of the window to select action:
•
Program: write loaded mhx/bin-file to MCU
•
Verify: compare loaded file to Flash contents
•
Blank: do a blank check
•
Read: read-out Flash content
•
Erase: perform a chip erase
After selecting a operation, tab ‘Action’ is automatically activated. Press ‘Start’ button to start
operation.
For further information on available settings in software and jumper settings on starterkits
have a look at ‘Options”
‘MB91F467D Options” (or other MCU type) and ‘Device Help’.
