Serial Asynchronous Flash Programming
Chapter 4 GALEP-Programmer
MCU-AN-300012-E-V13
- 26 -
© Fujitsu Microelectronics Europe GmbH
4.1.3 Serial Asynchronous Programming with GALEP-4 Programmer
For serial asynchronous programming no adapter is needed. Connect the starterkit via serial
cable to free COM port on your PC and do jumper settings as described in following
chapters depending on your board type. Additionally set DTR signal as reset signal. GALEP-
4 programmer has also to be connected to the PC to act as kind of hardware dongle.
Figure 22: Serial Asynchronous Programming with GALEP-4 Programmer
Start the GALEP32 programmer software and use ‘Load’ command to load a bin or hex file.
Select tab ‘Devices’ and browse to the correct device, e.g. MCU
Fujitsu
MB91F467D.
Choose ASYNC for serial asynchronous programming. Use ‘Select Device!’ button to accept
current selection.
Use the functions now enabled on the bottom of the window to select action:
•
Program: write loaded mhx/bin-file to MCU
•
Verify: compare loaded file to Flash contents
•
Blank: do a blank check
•
Read: read-out Flash content
•
Erase: perform a chip erase
After selecting a operation, tab ‘Action’ is automatically activated. Press ‘Start’ button to start
operation.
For further information on available settings in software and jumper settings on starterkits
have a look at ‘Options”
‘MB91F467D Options” (or other MCU type) and ‘Device Help’.
