Fujitsu LifeBook 200 Series, Руководство пользователя, Страница: 138 / 203

S e c t i o n F o u r
128
C A U T I O N
The memory upgrade module can
be severely damaged by electro-static
discharge (ESD). Be sure you are properly
grounded when handling and removing
the module.
Checking the Computer
Recognition of New Memory Capacity
When you have changed system memory
capacity by adding or removing a memory
upgrade module, be sure to check that your
notebook has recognized all of the memory.
You can check memory capacity by looking at
the Main menu of the setup utility:
1. Turn on power using the power switch.
2.Enter the setup utility by pressing the F2 key
as soon as the Fujitsu logo appears on the
screen. (See pages 53-54.)
9. Press the memory upgrade module down
into the compartment until it lodges under
the retaining clip. You will hear a click when
it is properly in place.
10. Replace the cover by hooking the tabs
under the rear edge of the compartment
opening and tilting down until flush with
the bottom of your notebook.
11. Replace the screws.
The memory upgrade module is not something
you routinely remove from your notebook.
Once it is installed, you can leave it in place
unless you want to increase system
memory capacity.
C A U T I O N
Before you install or remove the memory
upgrade module, save changes and close
all files and turn power off to your note-
book. (
See Power Off on pages 24-25. )
To Remove a Memory Upgrade Module:
1. Perform steps 1 through 5 of To Install a
Memory Upgrade Module.
2. Pull the clips sideways away from each side of
the memory upgrade module at the same
time. (Figure 4-13.)
3. While holding the clips out, remove the mod-
ule from the slot by lifting it up and pulling
towards the front of your notebook.
(Figure 4-13.)
4.Store the memory upgrade module in a static
guarded sleeve.
5. Replace the cover by following the instructions
in steps 10 and 11 of the instructions for To
Install a Memory Upgrade Module, or install
a new memory upgrade module and then
replace the cover by following the instructions
in steps 7 through 11 of the instructions
To Install a Memory Upgrade Module.