Fujitsu IP-9610, Руководство пользователя по оборудованию

Страница: 48 / 90

Chapter 3 Operation instructions
IP-9610
34
3.4
Special Use of Cancel Key
You can start IP-9610 by turning on the power while holding down the [CANCEL] key (for
about 10 seconds) until the RDY LED begins blinking in orange. Doing so starts the IP-9610 with
the initial IP address and subnet mask with which the IP-9610 is shipped from the factory
(CONSOLE: IP address 192.168.255.253, Subnet mask 255.255.255.252, LAN1: IP address
10.0.0.1, LAN2: IP address 10.0.0.2, Subnet mask: 255.0.0.0).
Use this function when making initial settings for IP-9610 from a control terminal (such as a PC
having a LAN interface) (*1).
*1 When you operate the IP-9610 with the default IP address, connect the device to a control
terminal and make setting from the terminal with the device disconnected from your network.
After making settings according to the requirements for your network, connect the device to
the network. If the device with the default settings made at the factory is connected to the
network, an unexpected problem may occur with your network.
If you start IP-9610 while holding the [CANCEL] key, set the IP addresses and subnet masks
of the control terminal to connect as follows:
- IP address on CONSOLE : 192.168.255.254
- Subnet mask on CONSOLE : 255.255.255.252
- IP address on LAN : 10.xxx.xxx.xxx
(xxx is any number from 0 to 255, excluding 10.0.0.0, 10.0.0.1, 10.0.0.2 and
10.255.255.255.)
- Subnet mask on LAN : 255.0.0.0
3.4