Fujitsu Inverter Halcyon, Руководство по эксплуатации

Страница: 13 / 20

En-12
MINIMUM HEAT OPERATION
To use MINIMUM HEAT OPERATION
Press the MIN. HEAT button (Fig.5
H
)
The OPERATION indicator lamp (green) (Fig. 3
5
) will go out, and the ECONOMY
indicator lamp (green) (Fig. 3
7
) will light.
To stop MINIMUM HEAT OPERATION
Press the START/STOP button (Fig.5
M
)
Then the OPERATION stops and the ECONOMY indicator lamp (green) (Fig. 3
7
) will
go out.
About the MINIMUM HEAT Operation
• The Heating mode will not operate if the room temperature is high enough.
• The room temperature can be maintained at 50°F by pressing the MIN. HEAT button
(Fig.5 H ) so as to prevent the room temperature from falling too far.
While MINIMUM HEAT OPERATION
is in progress, only the following
operation can be used.
• SWING
• SWING
• SLEEP
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 2
2
) more than
3 seconds and less than 10 seconds on the main unit control
panel.
To stop operation, press the MANUAL AUTO button (Fig. 2
2
) once again.
(Controls are located inside the intake grille)
MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the Remote Controller is lost or otherwise unavailable.
●
When the air conditioner is operated
with the controls on the MANUAL AUTO
button, it will operate under the same
mode as the AUTO mode selected on
the Remote Controller (see page 7).
●
The fan speed selected will be “AUTO”
and the thermostat setting will be stand-
ard.(76
°F )
OPERATION
●
Indicator Lamp
: Lighting : OFF
TIMER
ECONOMY
9315345295-03_OM_EN.indd 12 9315345295-03_OM_EN.indd 12 2010-9-3 15:09:58 2010-9-3 15:09:58