Fujitsu Halcyon ASU9RLS2, Дизайн и техническое руководство

Страница: 32 / 49

- (01 - 29) -
W
AL
L M
OU
NT
ED T
YP
E
AS
U
9-
15
R
LS2
W
AL
L M
OU
NT
ED T
YP
E
AS
U
9-
15
R
LS2
REMOTE CONTROLLER SIGNAL CODE SETTING
„ „
Use the following steps to select the signal code of the remote controller. (Note that
the air conditioner cannot receive a signal code if the air conditioner has not been set
for the signal code.)
(1) Press the START/STOP ( / ) button until only the clock is displayed on the
remote controller display.
(2) Press the MODE button for at least 5 seconds to display the current signal code
(initially set to ).
(3) Press the SET TEMP. ( / ) buttons to change the signal code between
→ → → .
Match the code on the display to the air conditioner signal code.
(4) Press the MODE button again to return to the clock display. The signal code will
be changed.
If no buttons are pressed within 30 seconds after the signal code is displayed, the system returns to the original
„
•
clock display. In this case, start again from step 1.
The air conditioner signal code is set to A prior to shipment.
„
•
REMOTE CONTROLLER TEMPERATURE UNIT
„ „
To change the temperature unit:
(1) Press the TEMP. (Up) button ( ) for at least 5 seconds to display the current temperature unit. (Factory setting: °F)
(2) Press the TEMP. buttons (
/ ) to switch the temperature unit. (°F ↔ °C)
(3) With either of pressing the START/STOP button or no additional button operation for 30 seconds in step 2., the
temperature unit currently selected will be set.