En-
4
Fig. 1 Indoor Unit
1
Operating Control Panel (Fig. 2)
2
MANUAL AUTO button
3
Remote Control Signal Receiver
4
Indicator Lamps (Fig. 3)
5
OPERATION Indicator Lamp (red)
6
TIMER Indicator Lamp (green)
●
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(see page 17 Auto Restart).
7
SWING Indicator Lamp (orange)
8
Intake Grille (Fig. 4)
9
Air Filter
0
Air Flow Direction Louver
A
Right-Left Louvers
(behind Air Flow Direction Louver)
B
Drain Hose
C
Inter Unit-Line
D
Air Cleaning Filter (optional)
Fig. 5 Outdoor Unit
E
Power Supply
F
Intake Port
G
Outlet Port
H
Pipe Unit
I
Drain port (bottom)
Fig. 6 Remote Control Unit
J
SLEEP button
K
MASTER CONTROL button
L
SET TEMP./SET TIME button (
)
M
Signal Transmitter
N
TIMER button
O
FAN CONTROL button
P
START/STOP button
Q
AIR FLOW DIRECTION button
R
SWING LOUVER button
Rear side (Fig. 7)
S
TIME ADJUST button
T
ACL button
(located inside battery compartment)
U
TEST RUN button
●
This button is used when installing the
unit, and should not be used under nor-
mal conditions, as it will cause the air con-
ditioner’s thermostat function to operate
incorrectly.
●
If this button is pressed during normal op-
eration, the unit will switch to test opera-
tion mode, and the Indoor Unit’s OPERA-
TION Indicator Lamp and TIMER Indicator
Lamp will begin to flash simultaneously.
●
To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
V
Remote Control Unit Display (Fig. 8)
W
Transmit Indicator
X
Clock Display
Y
Operating Mode Display
Z
Timer Mode Display
[
Fan Speed Display
\
Temperature Set Display
]
Timer Set Indicator
`
Temperature Set Indicator
NAME OF PARTS
