FLASH-CAN-48P
Chapter 3 Jumpers and Switches
© Fujitsu Semiconductor Europe GmbH
- 11 -
UG-900002-20
3.2 Operating-Mode
(S2)
The DIP-switch S2 is used to set the operating mode of the µC.
Ensure that the mode pin settings correspond to the operation-mode of the application.
For more detailed information please check the Hardware-Manual of the microcontroller.
DIP switch
Setting
Logical value
S2/1 (MD0)
ON (closed)
0 (low)
OFF (open)
1 (high)
S2/2 (MD1)
ON (closed)
0 (low)
OFF (open)
1 (high)
S2/3 (MD2)
ON (closed)
0 (low)
OFF (open)
1 (high)
S2/4
not connected (OFF)
S2/5
not connected (OFF)
S2/6
not connected (OFF)
S2/7 (P31)
ON (closed)
1 (high)
OFF (open)
0 (low)*
1
S2/8 (P30)
ON (closed)
1 (high)
OFF (open)
0 (low) *
1
Default: MD0, 1, 2 = 1 1 0 P30, P31 = 0 0
By default, the Single Chip Run-Mode is selected.
Note: *
1
Take care that the low-level is reached by the resistor-network N1 and the LEDs
D1/D2. In case that N1 is removed in order to free the Port, then P30 and P31
(MB90360/960 Series: P83 and P84) have to be connected manually to GND in case of
asynchronous programming (see chapter 4).
Dip-Switch S2
(default setting)
ON
OFF
1 2 3 4 5 6 7 8
MD0 MD1 MD2 nc nc nc P31 P30
P84 P83
