Flash-64P-M01/M09
Page
11
Jumper setting
Description
ON (closed)
SIN1 connected
SIN1 (J22)
OFF (open)
No connection
ON (closed)
SOT1 connected
SOT1 (J23)
OFF (open)
No connection
Figure 7: J22, J23 jumper setting for the Serial Interface (default: SIN1= 0N,
SOT1 = ON)
Some DIP switches of switch S1 (S1/5 and S1/6) are used to shortcut RTS to CTS
of the corresponding serial UART interface. S1/5 is used for the UART1
interface, S1/6 is used for UART0 interface. Especially for the serial download it
is necessary to shortcut RST with CTS of UART1, otherwise a communication
error will occur.
Description
ON (closed)
Shortcut RTS/CTS1
RTS/CTS 1 (S1/5)
OFF (open)
No shortcut
ON (closed)
Shortcut RTS/CTS0
RTS/CTS 0 (S1/6)
OFF (open)
No shortcut
Figure 8: S1 DIP switch setting for the Serial Interface (default: RTS/CTS 1=
0FF, RTS/CTS 0 = OFF)
1.4.5 Reset Generation
(J9, J10)
It is possible to use the DTR line of the UART interfaces to generate a reset for
the evaluation board. Therfore the jumpers J9 and J10 are used. Jumper J9 is used
to select whether the DTR line from UART1 or UART0 is used to generate a
reset. Jumper J10 is used to invert the polarity of the DTR line. So just change the
polarity for DTR if the reset is not generated correctly by DTR. To disconnect the
reset logic, just remove the jumper J10.
Note: If a Reset is active, the red Reset LED is lit. During normal operation
this LED should be off! If the reset LED is steadily on, change the DTR
polarity and check the power supply input voltage.
Содержание Flash-64P-M01
Страница 21: ...Flash 64P M01 M09 Page 21 ...
