Chapter 6 Daily Care
112
Cleaning the ADF (with Cleaning Paper)
The ADF can be cleaned with a sheet of Cleaning Paper
moistened with Cleaner F1.
As the scanner continues to feed the documents, paper dust
will accumulate inside the ADF and it may cause scanning
errors.
Cleaning should be performed approximately every 5,000
sheets scanned. Note that this guideline varies depending on
the types of documents you scan. For instance, it may be
necessary to clean the scanner more frequently when you
scan documents on which the toner is not sufficiently fused.
1
Turn on the scanner.
For details, refer to
"1.3 Turning the Power ON/OFF" (page 25)
.
The [Ready] screen is displayed on the LCD.
2
Press the [Menu] button.
The [Settings Menu] screen is displayed on the LCD.
3
Press the [ ] or [ ] button and select [2: Cleaning], then
press the [Scan/Enter] button to confirm.
The [Cleaning] screen is displayed on the LCD.
4
Select [1: Cleaning Sheet] by the [ ] or [ ] button, and
press the [Scan/Enter] button to confirm.
A message is displayed on the LCD.
5
Spray the Cleaning Paper with Cleaner F1.
6
Pull out the chute extensions according to the length of
the Cleaning Paper.
For details, refer to
"1.6 Setting Up the ADF Paper Chute (Feeder)"
7
Bring down the stacker, slide out stacker extension 1 and
stacker extension 2 towards you, and lift up the stopper
according to the length of the document.
For details, refer to
"1.7 Setting Up the Stacker" (page 30)
.
8
Load the Cleaning Paper in the ADF paper chute (feeder).
6.3 Cleaning the Inside
ATTENTION
z
Do not use water or mild detergent to clean the ADF.
z
It may take a long time to dry if an excessive amount of Cleaner F1 is
used. Use it in small quantity.
ATTENTION
Do not perform scanning from the scanner driver during cleaning.
