2
3. Align your system so that the fingerprint sensor and
camera on the back of the system are in the same ori-
entation as the matching openings on the back of the
case. (Figure 3)
4. Slide the system fully into the slate compartment and
re-attach the Velcro flap to the inside rear of the com-
partment.
5. To secure the front cover when the system is not in use,
pull the elastic strap over the rear of the case, covering
the webcam and fingerprint sensor openings.
Figure 2. Inserting the System
Adjusting the Angle
The case is designed so the system will sit upright in land-
scape configuration. To adjust the position, lie the cover flat
under the system, then lift the display and push it back-
wards until the bottom of the case edge rests in one of the
rows of card holders (Figure 4). Select an easel position to
suit your viewing preference.
Velcro Flap
Folio Case-FPC58-2967-02.fm Page 2 Friday, October 7, 2011 1:20 PM