Fujitsu D2863, Техническое руководство

Страница: 14 / 36

14 Technical Manual
D2863 (RX100 S6)
CE certificate of conformity
Notes about boards
●
During installation/deinstallation of the board, observe the specific
instructions described in the service supplement for the respective server.
●
Shut down the server and disconnect the power plug, before you make
modifications on an installed board.
●
To prevent damage to the board, the components and conductors on it,
please take great care when you insert or remove boards. Take great care
to ensure that extension boards are slotted in straight, without damaging
components or conductors on the board, or any other components, for
example EMI spring contacts.
●
Be careful with the locking mechanisms (catches, centring pins etc.) when
you replace the system board or components on it, for example memory
modules or processors.
●
Never use sharp objects (screw drivers) for leverage.
●
Do not damage or modify internal cables or devices. Doing so may cause a
device failure, fire, or electric shock.
●
Do not touch the circuitry on boards or soldered parts. Hold the metallic
areas or the edges of the circuit boards.
2.2 CE certificate of conformity
The board complies with the requirements of the EC directives
2004/108/EC regarding “Electromagnetic Compatibility” and
2006/95/EC “Low Voltage Directive”. This is indicated by the CE
marking (CE = Communauté Européenne).
Compliance was tested in a typical PRIMERGY configuration.