Fujitsu CW35 Series, Руководство пользователя

Страница: 35 / 85

2
Hardware Installation
35
2.9.15 Wake-On-LAN Connector
The system board supports the Wake-On-LAN function. This function
will allow the network to remotely power-on a Soft Power Down
(Soft-Off) PC. However, if your system is in the Suspend mode, you
can power-on the system only through an IRQ or DMA interrupt.
To use the Wake-On-LAN function, you must enable the “Resume on
LAN” field in the Power Management Setup of the BIOS. Your LAN
card package should include a cable. Connect one end of the cable
to the wakeup header on the card and the other end to location
J16 on the system board. The network will detect Magic Packet and
assert a wakeup signal to power-up the system. Refer to the add-in
card’s manual for details. Note: Your LAN card must support the
remote wake up function.
Important:
If you are using the (1) Suspend to RAM, (2) Wake-On-
Keyboard/Mouse and (3) Wake-On-LAN functions all at the
same time, the 5VSB power source of your power supply must
support a minimum of
≥
1A. A
≥
720mA 5VSB power source is
sufficient if you are using only one or two of these functions.
Pin
1
2
3
Function
WOL
Ground
+5VSB (720mA)
Pin
1
2
3
4
J12 - Sony
CD-L
CD-G
CD-G
CD-R
J10 - Sony
CD-L
CD-G
CD-G
CD-R
J11 - Mitsumi
CD-R
CD-G
CD-L
CD-G