Fujitsu B32-9 TS UHD, Руководство по эксплуатации

Страница: 45 / 52

Troubleshooting
Troubleshooting
Should an error occur, fi rst check the following points. If the distortion is still not eliminated,
the monitor should, if possible, be checked on another computer.
If you cannot solve the problem, please contact our Service Desk.
Having this problem? Check the following points:
No screen display
Power indicator is lit
► Check whether the computer is switched on.
► Check whether the data cable for the
monitor is correctly screwed into the monitor
port on the computer.
► Press any key on the computer keyboard.
The computer may be in power saving
mode.
► Alter the brightness and/or contrast until you
get a picture.
Message:
No Signal
► Check whether the data cable for the
monitor is correctly screwed into the monitor
port on the computer.
► Check whether the computer is switched on.
Message:
Frequency out of range:
## kHz / ## Hz
Please change the display mode
to 3840 x 2160 with 60 Hz
The input signal (horizontal frequency and
refresh rate) at the displayed input does not
correspond to the technical data for the monitor.
► Reboot the system after connecting to the
monitor. The VGA interface does not support
"Hot Plugging".
► Adjust the video frequency range using the
computer software (see documentation for
the computer or display adapter).
► Set a different screen resolution using the
computer software (see documentation for
the computer or display adapter).
Picture position not correct The monitor recognises an unde fi ned mode (see
chapter "Technical speci fi cation", Page 43 ).
► Run the function Auto adjust (see Chapter
"Setting screen display", Page 21 ).
Picture is shaking ► Check whether the data cable for the
monitor is correctly screwed into the monitor
port on the computer.
► Run the function Auto adjust (see Chapter
"Setting screen display", Page 21 ).
Fujitsu 41