En-11
Strip 10 mm
Ring terminal
Sleeve
Screw with
special washer
Cable
Ring terminal
Terminal block
Screw with
special
washer
Cable
Ring
terminal
WARNING
• Use ring terminals and tighten the terminal screws to the
specified torques, otherwise, abnormal overheating may
be produced and possibly cause heavy damage inside
the unit.
Terminal number
Tightening torque
M4 screw
(Power supply/L, N, GND)
1.2 to 1.8 N·m
(12 to 18 kgf·cm)
6.3.2. Transmission and Remote control cable
80 mm
30 mm
Shielded
cable (no film)
Transmission cable
Remote control cable
30 mm
• Connect remote control and transmission cables as shown
in Fig. B.
• When the two cables are attached.
Fig. B
Different
diameter
Connect to
one side
NO GOOD
NO GOOD
OK
WARNING
• Tighten the terminal screws to the specified torques,
otherwise, abnormal overheating may be produced and
possibly cause heavy damage inside the unit.
Terminal number
Tightening torque
M4 screw
(Transmission/X1, X2)
(Remote control/Y1, Y2, Y3)
0.8 to 1.2 N·m
(8 to 12 kgf·cm)
CAUTION
• To peel the film from the lead cable, use a dedicated tool
that will not damage the conductor cable.
• When installing a screw on the terminal block, do not cut
the cable by overtightening the screw. On the other hand,
an undertightened screw can cause faulty contact, which
will lead to a communication failure.
• Remove it with the following sequence in case of the state
with the grille.
(1) Open the intake grille.
Screw cover
Intake grille
9371057033-02_IM_en.indd 11
2/20/2009 3:13:34 PM
