En-12
SWING OPERATION
MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the Remote Controller is lost or otherwise unavailable.
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 2
2
) for three seconds
on the main unit control panel.
To stop operation, press the MANUAL AUTO button (Fig. 2
2
) for three seconds.
●
When the air conditioner is operated
by the controls on the Main Unit, it will
operate under the same mode as the
AUTO mode selected on the Remote
Controller
(see page 7).
●
The fan speed selected will be “AUTO”
and the thermostat setting will be
standard (24
°C
).
Begin air conditioner operation before performing this procedure.
To select SWING Operation
Press the SWING button (Fig. 5
Q
).
The SWING Display (Fig. 6
Y
) will light.
In this mode, the Airflow Direction Louvers will swing automatically to direct the air
flow both up and down.
To stop SWING Operation
Press the SWING button (Fig. 5
Q
) once again.
The SWING Display (Fig. 6
Y
) will go out.
Airflow direction will return to the setting before swing was begun.
About Swing Operation
During cooling/Dry mode : Swings between
1
and
3
.
During heating mode
: Swings between
3
and
6
.
●
The SWING operation may stop temporarily when the air conditioner’s fan is not
operating, or when operating at very low speeds.
