Fujitsu ARXC36L, Руководство по установке

Страница: 10 / 28

En-10
Strip 25 mm
Loop
Screw with
special washer
Cable
Cable end (Loop)
Terminal block
Screw with
special
washer
Cable end
(Loop)
Cable
WARNING
• When using solid core cables, do not use the ring
terminal. If you use the solid core cables with the ring
terminal, the ring terminal’s pressure bonding may
malfunction and cause the cables to abnormally heat up.
B. For strand wiring
(1) Use ring terminals with insulating sleeves as shown in the
figure below to connect to the terminal block.
(2) Securely clamp the ring terminals to the cables using an
appropriate tool so that the cables do not come loose.
(3) Use the specified cables, connect them securely, and
fasten them so that there is no stress placed on the
terminals.
(4) Use an appropriate screwdriver to tighten the terminal
screws. Do not use a screwdriver that is too small,
otherwise, the screw heads may be damaged and prevent
the screws from being properly tightened.
(5) Do not tighten the terminal screws too much, otherwise,
the screws may break.
(6) See the table for the terminal screw tightening torques.
(7) Please do not fix two power supply cables with one screw.
Strip 10 mm
Ring terminal
Sleeve
Screw with
special washer
Cable
Ring terminal
Terminal block
Screw with
special
washer
Cable
Ring
terminal
WARNING
• Use ring terminals and tighten the terminal screws to the
specified torques, otherwise, abnormal overheating may
be produced and possibly cause heavy damage inside
the unit.
Tightening torque
M4 screw
(Power supply/L, N, GND)
1.2 to 1.8 N·m
(12 to 18 kgf·cm)
6.3.2. Transmission and Remote control cable
Transmission cable
Shielded
cable (No film)
25 mm
35 mm
Remote control cable
20 mm
• Connect remote control and transmission cables as shown
in Fig. B.
• When the two cables are attached.
Fig. B
Screw
Terminal block
Cable of the
same caliber:
OK
Cable of the
different caliber:
NO GOOD
Cable
WARNING
• Tighten the terminal screws to the specified torques,
otherwise, abnormal overheating may be produced and
possibly cause heavy damage inside the unit.
Tightening torque
M3.5 screw
(Transmission/X1, X2)
(Remote control/Y1, Y2, Y3)
0.8 to 1.0 N·m
(8 to 10 kgf·cm)
9373870036_02_IM_en.indd 10 25/2/2552 9:17:33