Cleaning the Intake Grille
1. Remove the Intake Grille.
1
Place your fingers at both lower ends of the grille
panel, and lift forward; if the grille seems to catch
partway through its movement, continue lifting up-
ward to remove.
2
Pull past the intermediate catch and open the Intake
Grill wide so that it become horizontal.
2. Clean with water.
Remove dust with a vacuum cleaner; wipe the unit with
warm water, then dry with a clean, soft cloth.
3. Replace the Intake Grille.
1
Pull the knobs all the way.
2
Hold the grille horizontal and set the left and right
mounting shafts into the bearings at the top of the
panel.
1
2
2
1
2
CLEANING AND CARE
CAUTION!
●
Before cleaning the air conditioner, be sure to turn it off and disconnect the Power Supply Cord.
●
Be sure the Intake Grille (Fig. 1
8
) is installed securely.
●
When removing and replacing the air filters, be sure not to touch the heat exchanger, as personal
injury may result.
Cleaning the Air Filter
1. Open the Intake Grille, and remove the air
filter.
Lift up the air filter’s handle, disconnect the two lower
tabs, and pull out.
2. Remove dust with a vacuum cleaner or
by washing.
After washing, allow to dry thoroughly in a shaded place.
3. Replace the Air Filter and close the Intake
Grille.
1
Align the sides of the Air Filter with the panel, and
push in fully, making sure the two lower tabs are re-
turned properly to their holes in the panel.
2
Close the Intake Grille.
(For purposes of example, the illustration shows the unit
without Intake Grille installed.)
●
Dust can be cleaned from the Air Filter either with a
vacuum cleaner, or by washing the filter in a solution of
mild detergent and warm water. If you wash the filter, be
sure to allow it to dry thoroughly in a shady place before
reinstalling.
●
If dirt is allowed to accumulate on the Air Filter, air flow
will be reduced, lowering operating efficiency and in-
creasing noise.
●
During periods of normal use, the Air Filters should be
cleaned every two weeks.
Intake Grille
Air filter handle
Hooks (two places)
Intake Grille
Hooks (two places)
When using the optional Air Cleaning Filter
●
Install the optional Air Cleaning Filter set (APS-03B) as instructed (installation instructions are furnished with the Air Clean-
ing Filter set).
●
When used for extended periods, the unit may accumulate dirt inside, reducing its performance. We recommend that the
unit be inspected regularly, in addition to your own cleaning and care. For more information, consult authorized service
personnel.
●
When cleaning the unit’s body, do not use water hotter than 40 °C, harsh abrasive cleansers, or volatile agents like
benzene or thinner.
●
Do not expose the unit body to liquid insecticides or hairsprays.
●
When shutting down the unit for one month or more, first allow the fan mode to operate continuously for about one-half
day to allow internal parts to dry thoroughly.
Intake Grille
Mounting
shaft
Knob
Intake Grille
Mounting shaft
Bearing
Knob
Mounting
shaft
Knob
12
