En-4
To start/stop the WEEKLY timer operation
To start
Select
.
(If the air conditioner is running, the day display is replaced
by the temperature display.)
Next scheduled ON or OFF time
The current time
To stop
Select “NON STOP,” “OFF TIMER” or “ON TIMER”.
To review the WEEKLY timer settings
* Press the START/STOP button to stop the air conditioner, and then proceed as follows.
1
2
3
Select “WEEKLY”.
Select the day that
you want to check.
Switch between
“WEEKLY 1” or
“WEEKLY 2” time dis-
plays.
To cancel the selected time settings
* Press the START/STOP button to stop the air conditioner, and then proceed as follows.
1
2
Hold down the
▼
side until the time display becomes blank
“-:--”.
3
(The “WEEKLY 1” OFF time is deleted and replaced by a
flashing blank pattern “--:--”.)
4
(The “WEEKLY 2” ON time starts flashing.)
5
If you want to delete “WEEKLY
2”, repeat steps
2
to
4
.
6
If you want to delete the setting
of another day, press the
TEMP./DAY button to select an-
other day, and then repeat
steps
2
to
10
.
7
Press for 3 seconds.
(“WEEKLY” flashes and then the clock
display reappears.)
NOTES
(1)
PRECAUTIONS DURING WEEKLY TIMER SETUP
Setup is not possible in the following cases, so amend the time.
• Be sure to set the ON time first, then the OFF time. If either
the ON time or the OFF time is not set correctly, the timer will
not operate properly.
• The WEEKLY 2 settings cannot be set earlier than the WEEKLY
1 settings.
• The WEEKLY 1 and WEEKLY 2 time spans cannot overlap.
(2)
• The earliest OFF time you can set is 5 minutes after the ON
time.
• The latest OFF time is 23:55 on the subsequent day.
(3)
You do not need to set values for both WEEKLY 1 and WEEKLY
2. If you wish, you can set values only for WEEKLY 1 or only for
WEEKLY 2.
(4)
• If you set the OFF time to occur on the day following the ON
time, the NEXT DAY caption appears on the display.
• Operation continues if the OFF time for WEEKLY 1 is the same
time as the ON time for WEEKLY 2.
(5)
If the WEEKLY 1 and WEEKLY 2 settings are set to run consecu-
tively, the temperature and operation mode settings become
the WEEKLY 2 settings after the ON time for WEEKLY 2.
ON COOL 26
°
C
ON DRY 25
°
C
OFF
Perform steps
1
to
3
in “To set the WEEKLY timer.”
(P. 3)
Select the day to cancel.
(6)
For Heat Pump models, operation may not occur according to
the settings for the HEAT timer during the cooling mode and for
the COOL or DRY timer during the heating mode.
(7)
Even if the timer operation is set, the timer indicator lamp of the
indoor unit does not light up. (The timer indicator lamp is used
for wireless remote controllers only.)
