Fujitsu Airstage AUXB07L, Руководство по установке

Страница: 11 / 33

En-11
Strip
25
mm
Loop
Screw with
special washer
Screw with
special washer
Cable end
(Loop)
Cable end
(Loop)
Cable
Cable
Terminal block
WARNING
• When using solid core cables, do not use the ring terminal. If
you use the solid core cables with the ring terminal, the ring
terminal's pressure bonding may malfunction and cause the
cables to abnormally heat up.
B. For strand wiring
(1) Use ring terminals with insulating sleeves as shown in the
figure below to connect to the terminal block.
(2) Securely clamp the ring terminals to the cables using an
appropriate tool so that the cables do not come loose.
(3) Use the specified cables, connect them securely, and fasten
them so that there is no stress placed on the terminals.
(4) Use an appropriate screwdriver to tighten the terminal screws.
Do not use a screwdriver that is too small, otherwise, the screw
heads may be damaged and prevent the screws from being
properly tightened.
(5) Do not tighten the terminal screws too much, otherwise, the
screws may break.
(6) See the table for the terminal screw tightening torques.
(7) Please do not fix two power supply cables with one screw.
Strip
10
mm
Sleeve
Screw with
special washer
Screw with
special washer
Ring terminal
Cable
Cable
Terminal block
Ring terminal
Ring
terminal
WARNING
• Use ring terminals and tighten the terminal screws to the
specified torques, otherwise, abnormal overheating may be
produced and possibly cause heavy damage inside the unit.
Tightening torque
M4 screw
(Power supply /L, N, GND)
1.2 to 1.8N
•
m
(12 to 18 kgf
•
cm)
6.3.2. Transmission and Remote control cable
30
mm
40
mm
Transmission cable
Shielded
cable (no film)
30
mm
Remote control
cable
• Connect remote control and transmission cables as shown
in Fig. C.
Fig. C
OK NO GOOD NO GOOD
Different
diameter
Connect to
one side
WARNING
• Tighten the terminal screws to the specified torques,
otherwise, abnormal overheating may be produced and
possibly cause heavy damage inside the unit.
Tightening torque
M3 screw
(Transmission /X1, X2)
(Remote control /Y1, Y2, Y3)
0.5 to 0.6N
•
m
(5 to 6 kgf
•
cm)
CAUTION
• To peel the film from the lead cable, use a dedicated tool that
will not damage the conductor cable.
• When installing a screw on the terminal block, do not cut
the wire by overtightening the screw. On the other hand, an
undertightened screw can cause faulty contact, which will
lead to a communication failure.