11
INDICATOR LED
• POWER:
When LED is on the SPS has input power.
• NO FLOW:
When illuminated, the flow switch has detected no flow and SPS is NOT
generating chlorine. A flashing LED indicates that the flow is restored, but there will
be a 60 second delay before generation is reestablished.
• LOW SALT:
When flashing, the salt level is low (below 2500 ppm) and SPS is
generating at low efficiency. When illuminated steady, the salt level is too low and
SPS has shut down.
• Note:
Before adding large quantities of salt, it is advisable to have your salt level
professionally checked.
• Note:
If the Salt level is at the correct level but the LOW SALT LEVEL is still on,
the cell has to be replaced.
• HIGH SALT:
When illuminated the salt level is around 4200 ppm. When illuminated
steady, salt level is higher than 4200 ppm and SPS has shut down. The pool water
must be diluted with fresh water before operation is restored.
OPERATION
By familiarizing yourself with the operation of the SPS generator, you can achieve
maximum performance for your pool. When chemical levels are in the recommended
range, there are FOUR factors that you can control which directly contribute to the
amount of chlorine the SPS will generate:
•
Filter time each day (hours)
•
The amount of salt in the pool
•
The “Desired Level %” setting
•
Stabilizer level in the water.
To find the optimum “Desired Level %” setting, start at a fairly high setting and work
downward. It will take a few days of adjustments to find the ideal setting for your pool.
Once determined, it should only take minor adjustments. The SPS control will not
produce chlorine at temperatures below 50°F. If your pool water is colder than 50°F,
you must chlorinate manually.
MAINTAINING THE SYSTEM
•
To maintain maximum performance, it is recommended that you remove and visually
inspect the cell every 3 months.
•
The SPS electrolytic cell has a self-cleaning feature incorporated into the electronic
control’s logic. In most cases this self-cleaning action will keep the cell working at
optimum efficiency. In areas where water is hard (high calcium and/or mineral content)
and in pools where the water chemistry has gotten “out of balance”, the cell may require
periodic cleaning every 3 months. After cleaning, if the LOW SALT is always ON even
with a good salt level, the cell may be worn and require replacement.
Содержание SaltPool
Страница 13: ...MOUNTING THE SPS CONTROL ...