6
1
Baffle Filter
Align the baffle filter by placing the bottom of the
baffle filter in the catches, hold it in place with
one hand, and use the other hand to fasten each
filter screw at the top firmly (turn clockwise to
fasten).
* When cleaning is finished, be sure to return the
power supply as before; connect the power plug to
the wall receptacle, or switch on the breaker.
2
Rectifier Panel
Holding the rectifier panel with both hands, place
the bottom of the panel in bottom of the catches
and in line with the rectifier panel mounting guide
holes.
Tighten the rectifier panel screw to attach the
panel firmly.
Attaching Cleaned Parts
3
Oil Tray
Hold the tab and set the oil tray on the guide rail
of the cooker hood, then push it completely to
the end.
Note
Make sure that the rectifier panel is fixed securely. It
may be a cause of dropping if not fixed firmly.
Note
If the oil tray is not installed properly, it may result in
oil-drip, injury by dropping, etc.
Filter screw
Tighten
Baffle filter
Catch
Rectifier panel
Catch
Rectifier panel
mounting guide hole
Rectifier panel screw
4
Oil receiving cover
Holding the oil receiving cover with one hand at
each end, align the slits on the bottom panel of
the body with the slits on the cover. Swivel the
top part of the cover up and to the body in the
direction shown by the arrow. Make sure that the
catches at both ends of the oil receiving cover
are firmly latched.
Oil receiving cover
Catch
Oil recieving cover
Replacing the Lamp
This range hood is fitted with Philips Tornado Spiral
energy-saving light bulbs (8W [40W], E14, Cool
daylight).
When the lamp in use burns out, please replace the
light bulb with a commercially purchased compact
fluorescent light bulb or mini light bulb described
below.
Compact Fluorescent light bulb:
Philips Tornado Spiral energy-saving light bulb (8W
[40W], E14, Cool daylight) or equivalent product
(rated voltage: 220/230/240V; in the base diameter
14mm) (dimension limits for mounting: length of
100mm or less; diameter of 47mm or less).
Mini light bulb:
Rated voltage of 220/230/240V; in the base diameter
14mm.
Note
Before replacing the lamp, be sure to disconnect the power
plug from the wall receptacle,
or switch off the breaker.
Note
When replacing, be sure to use a same voltage bulb
with the power voltage supplied.
