- Select the required burner by referring to the
symbols located near the knobs (e,g:for the
right-hand burner)
- Each burner is supplied by a tap.To turn this
on,press it down and turn it anti-clockwise
The gas is turned off.when the knob points to
：
To turn the gas down the knob should be tur-
ned from
“
”
to
“
”
.
- Your hob is equipped with a burner ignition
device integrated into the knobs:To ignite a burner.
Press down and turn the knob anti-clockwise untill
It is pointing to the maximum position
“
”
Keep the knob pressed down to activate a
series of sparks until the burner lights.
- Select the required burner by referring to the
symbols located near the knobs
- A tap equipped with a gas safety device
controls each burner and if the flame is
accidentally extinguished(spills, draughts etc...)
This device automatically closes down the gas
supply and prevents gas escaping.
- Your hob is equipped with a burner ignition
device integrated into the knobs.
- To ignite a burner. Press down and turn the
knob anti-clockwise until it is pointing to the
maximum position
“
”
- To turn the gas down the knob should be
turned from
“
”
to
“
”
When the flame appears keep the knob well
pressed down for a few seconds to activate
the safety device.
Release. If the flame is extinguished,repeat
the operation.
Follow the same procedure described above to ignite the burners. In this case, however, once you have
turned the knob to open setting,hold it pressed in for 10 seconds. If for any reason the burner
flame goes out, the safety valve automatically shuts off the gas supply to the burner in question.
In the even of the burner flames being accidentally extinguished,turn off the burner control and do not
attempt to re-ignite the burner for at least 1 minute.
The ignition device shall not be operated for more than 15 second.If after 15 second the burner has not
lit,stop operating the device and open the comartment door and / or wait at least I minute before
attempting a further ignition of the burner.
Placed the saucepan on the selected burner and activate.
If the flame is accidentally extinguished just re-light it normally following the ignition instructions.
Your hob is equipped with an integrated ignition device, It is,therefore,normal that a series of sparks is
produced on all the burners.
If it becomes difficult to tum a knob DO NOT FORCE IT.Have the Installer see to it immodiately.
In the case of a power cut,automatic lighting will not work,In these circumstances,matches may be used
1 4
