11
Prior to installation, ensure that the local distribution conditions (nature of the gas and gas
pressure) and the adjustment conditions of the appliance are compatible.
These hobs are designed to be used by private individuals in their homes.
Since this appliance is not connected to a combustion products evacuation device, it must be
installed in accordance with current installation regulations and used in a well - ventilated
place,particular attention should be given to the relevant requirements regarding ventilation.
The hob must be built into the worktop as illustrated on the corresponding figure of a support
cupboard. This worktop must be at least 3 cm thick and heat - resistant or else coated with a
heat resistant material.
A distance of at least 5 cm from the appliance border to the wall and a sideclearance of at
least 15 cm should be left to the right and left of the hob.In case those units are above the
appliance, these must be placed at a minimum distance of 80 cm from the appliance top.
It is advisable that a horizontal partition is put under the hob,it must be placed between 10 to
15cm from the bottom of the worktop. In any case, do not keep any sprays or pressurized
containers in the compartment,which could be just under the hob.
A
A
Back w
all
FRO
NT
A
B
50mm
Cut-Out Dimension - Please refer Page 7 for selected model.
B
B
