Opternus GmbH
optische Spleiss- und Messtechnik
Opternus GmbH
Optische Spleiss- & Messtechnik
Bahnhofstr. 5
D-22941 Bargteheide
Tel. +49(0)4532-20 44-0
Fax +49(0)4532-20 44-25
Büro Süd:
Wäldenbronner Str. 2
D-73732 Esslingen
Tel. +49(0)711-3 10 59 99-0
Fax +49(0)711-3 10 59 99-99
überreicht durch:
©Opternus GmbH
Ju
li
2012
E-Mail:
i
nfo@
o
pternus.de - www.
o
pternus.de
- www.opternus-shop.de
Specifications and descriptions are subject to change without prior notice.
Specifications
FuseConnect-MPO
Assembly Manual
1. Connector components and tools
Fuseconnect-MPO is assembled with the parts shown below.
1.1. Connector unit
1.2. Assembly tools
2. Fiber preparation tools
3. Operation Procedure
3.1. Preparation
3.1.1. Insert boot
3.2. Cable Processing
3.2.1. Strip fiber
3.2.2. Cleaning; screening
Clean the fiber surface after the coating is removed with cotton dipped in alcohol.
Bend the fiber up and down, left and right 3 times slowly with the finger (about
60 ) to verify that it does not break.
3.2.3. Cleave fiber
3.3. Fiber Termination
3.3.1. Preparation
3.3.2. Fusion splice
Fiber Cleaver (CT-30)
Fiber Stripper (HJS-02)
Set fiber holder and connector
holder on fusion splicer
Insert boot unit through the ribbon
fiber.
Cleave fiber leaving
10mm of bare fiber
Note: During fiber preparation, broken fiber may get injure the eyes or
other parts of the body. Always wear eye protection when handling optical
fibers and dispose of any cut or cleaved ends properly.
Mechanical
clamp
cover
Boot unit
Connector holder
Housing assembly
Fusion splicer (60R)
Fiber holder (FH-50-12)
10mm
Splice cable to connector
35mm
Set ribon fiber on
fiber holder
Set fiber holder on fiber
stripper
Note:There is no gap
between fiber holder and
stripper
Strip ribon fiber
Note:There is no gap
between fiber holder and
cleaver
Set fiber holder on cleaver
Mechanical sleeve installer base
Mechanical
clamp
Body
Mechanical sleeve press
