FujiFilm UA125x8BESM-S35, Руководство по эксплуатации

Страница: 39 / 84

-･5･-
Description in this section applies to installation of a lens onto a studio camera.
For installation onto a portable camera, a lens supporter is required. Refer to the operation manual of the lens supporter.
Note1.
Prior to installation, turn off the power of the camera.
Note2.
After installation, when the power of the camera is turned on, the initial settings of the stabilizer mechanism
and the main lens are carried out for about ten seconds and several seconds respectively at the same time.
During the setting of the stabilizer mechanism, do not perform panning or tilting operation of the camera; the
indicator of the optical stabilizer control unit linked to the lens blinks.
During the setting of the main lens, the operation of the lens cannot be performed. After the setting, the zoom
returns to its former position.
WARNING
Be sure to attach all the parts securely. Dropping any parts from a height may cause severe
accidents.
■ Installation onto Studio Camera
a. Holding the lens package with both hands, hang the hook at the top rear of the package on the hook at the top front
of the camera, and align the pin on the lens mount with the groove in the camera mount.
b. Swing the package down so that the spring pin on the lens mount gets in the hole in the camera mount. In this
procedure, the electrical connections, via the connectors on both mounting surfaces, is automatically made.
c. Securely fix the lens package by means of the lens mount locking knob attached to the camera mount.
Note. Make sure to adjust the flange focal length when installing the lens on a camera for the first time or install-
ing it on another camera (refer to the next page for details).
LENS
LENS MOUNT LOCKING KNOB
CAMERA
HOOKS
MEMO
LENS MOUNT (WITH HOOK) SURFACE
５. INSTALLATION