FujiFilm UA107x88.4BESM-T35, Руководство по эксплуатации

Страница: 30 / 90

- ⅳ -
■ Before Installing onto Camera
When it is required to install this lens on a Sony studio camera (Ex. HDC- 2 000) or on a Sony large lens adapter
(Ex. HDLA-1500), remove the pin on the bayonet mount of the lens, and attach it to the threaded hole in the
mount frame. To install this lens on another camera, reinstall the pin on its former position.
THREADED HOLE
PIN
PRIOR TO USE
There are twelve desiccant bags in the trunk. Take out two of them to use. The rest should be used when
the exchange of the desiccant is required.
Loosen the two lens shroud attaching knobs on the both sides of the lens. Draw the shroud towards the front
of the lens to detach it from the body.
Remove the four screws to take off the lid.
Take out the desiccant bag for storage.
Fold two new desiccant bags and put them in the desiccant enclosure place.
Put the detached lid in its place and reinstall the four screws. Finally, reinstall the lens shroud.
Note 1. Perform the above procedure in a dust-free place.
Note 2.
a.
b.
c.
d.
e.
f.
NEW DESICCANT BAG
DESICCANT BAG
FOR STORAGE
DESICCANT ENCLOSURE PLACE
In a humid region, it is recommended to change the desiccant bags two times a year. The desiccant being
jellied indicates the time when it must be exchanged.
■
■ Enclosure of Desiccant
The inside of this lens is able to enclose desiccant in order to eliminate humidity that may mist the surfaces of
the internal glasses. A desiccant bag for storage was enclosed in the desiccant enclosure place before shipment
at the factory. Prior to use, take out this bag first, and put new desiccant bags in that place as follows:
Cautions when using the lens supporter
When using this lens with a Fujinon lens supporter (ELH-*) attached, use a power source connecter (see “Name
and Function of Each Part”) to supply power from the lens side. If power is not supplied, correct operation may
not occur.
PRIOR TO USE