FujiFilm OPC-G1-DEV, Руководство пользователя

Страница: 38 / 41

37
ENGLISH
Chapter 12 SPECIFICATIONS
12.1 General Specifications
Install the inverter equipped with the communications card in an environment that satisfies the requirements
listed below.
Item Specifications
Site location Indoors
Surrounding temperature Refer to the FRENIC-MEGA Instruction Manual, Chapter 2.
Relative humidity 5 to 95% (No condensation)
Atmosphere The inverter must not be exposed to dust, direct sunlight, corrosive gases,
flammable gases, oil mist, vapor or water drops.
Pollution degree 2 (IEC60664-1)
(Note)
The atmosphere can contain a small amount of salt.
(0.01 mg/cm
2 or less per year)
The inverter must not be subjected to sudden changes in temperature that will
cause condensation to form.
Altitude 1,000 m max.
Atmospheric pressure 86 to 106 kPa
Vibration Refer to the FRENIC-MEGA Instruction Manual, Chapter 2.
(Note) Do not install the inverter in an environment where it may be exposed to lint, cotton waste or moist dust or dirt
which will clog the heat sink of the inverter. If the inverter is to be used in such an environment, install it in a
dustproof panel of your system.
12.2 DeviceNet Specifications
Item Specifications
Network input voltage 11 to 25 V
Network power consumption 75 mA at maximum (24 VDC)
(Note) The network power is supplied by an external power source.
No. of nodes connected 64 at maximum (including the master)
MAC ID 0 to 63
Insulation 500 VDC (photocoupler insulation)
Transmission rate 500 kbps/250 kbps/125 kbps
Transmission rate
500 kbps 250 kbps 125 kbps
Trunk line length 100 m 250 m 500 m
Drop line length 6 m 6 m 6 m
Maximum cable length
(Trunk line: thick cable
Drop line: thin cable)
Total length of drop lines 39 m 78 m 156 m
Messages supported 1. I/O Message (Poll, Change of State)
2. Explicit Message
Vendor ID 319 (Fuji Electric Group)
Device type AC drive (code: 2)
Product code 9219
Model name OPC-G1-DEV
Applicable device profile AC Drive
No. of input/output bytes Selectable between 4 and 8 bytes for input and output (independently)
Applicable DeviceNet
Specifications CIP Specifications Volume 1, Edition 2.2 Japanese version and Volume
3, Edition 1.1 Japanese version
(Certified by ODVA Japan for Conformance Test Version 20)
Node type Group 2 only server