28
■
CAUTIONS on Handling INSTAX MINI Instant Film and Prints
See below for film activities to be avoided.
Bluetooth® Device Cautions
IMPORTANT: Read the following notices before using this
camera’s built-in Bluetooth transmitter�
■
Use only as part of a Bluetooth network�
Do not use in applications requiring a high degree of reliability,
for example in medical devices or other systems that may
directly or indirectly impact human life. When using the device
in computer and other systems that demand a greater degree of
reliability than Bluetooth networks, be sure to take all necessary
precautions to ensure safety and prevent malfunction. FUJIFILM
Corporation and its affiliates do not accept liability for damages
resulting from unauthorized use or misuse.
■
Use only in the country in which the device was purchased�
This device conforms to regulations governing Bluetooth
devices in the country in which it was purchased. Observe
all location regulations when using the device. FUJIFILM
Corporation and its affiliates do not accept liability for problems
arising from use in other jurisdictions.
■
Wireless data (images) may be intercepted by third parties�
FUJIFILM Corporation and its affiliates are not responsible for
intercepted transmissions, or for unintended image uses.
■
Do not use the device in locations subject to magnetic fields,
static electricity, or radio interference�
Do not use the transmitter in the vicinity of microwave ovens or
in other locations subject to magnetic fields, static electricity,
or radio interference that may prevent reception of wireless
signals. Mutual interference may occur when the transmitter is
used in the vicinity of other wireless devices operating in the
2.4 GHz band.
■
The Bluetooth transmitter operates in the 2�4 GHz band� The
standard output is approximately 3�16 mW�
■
This device operates on the same frequency as commercial,
educational, and medical devices and wireless transmitters�
It also operates on the same frequency as licensed transmitters
and special unlicensed low-voltage transmitters used in radio-
frequency identification tracking systems for assembly lines and
in other similar applications.
■
To prevent interference with other devices operating on the
same frequency, observe the following precautions�
Confirm that the radio-frequency identification transmitter
is not in operation before using this device. If you notice
that this device causes interference in low-voltage radio-
frequency identification tracing systems, contact a FUJIFILM
representative.
■
The following may be punishable by law:
– Disassembly or modification of this device.
– Removal of device certification labels.
For customers in the USA:
FCC Statement
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
For more information, access the website below.
https://instax.com/mini_evo/en/spec.html
CAUTION
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for
help.
Changes or modifications not expressly approved by Fujifilm
responsible for compliance could void the user’s authority to
operate the equipment.
This transmitter must not be co-located or operated in conjunction
with any other antenna or transmitter.
The available scientific evidence does not show that any health
problems are associated with using low power wireless devices.
There is no proof, however, that these low power wireless devices
are absolutely safe. Low power wireless devices emit low levels of
radio frequency energy (RF) in the microwave range while being
used. Whereas high levels of RF can produce health effects (by
heating tissue), exposure of low-level RF that does not produce
heating effects causes no known adverse health effects. Many
studies of low-level RF exposures have not found any biological
effects. Some studies have suggested that some biological
effects might occur, but such findings have not been confirmed
by additional research. This device has been tested and found
to comply with FCC radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF)
Exposure Guidelines.