FujiFilm Fujica AX-1, Руководство по ремонту и список запчастей

Страница: 93 / 159

REASSEMBLY, REPAIR AND ADJUSTMENT
FUJICA A X - 1
14. Installing electrical parts and wiring
1 4 - 1 Installing parts
a. Printed circuit board (110B280610).
o Place the printed circuit board (110B28O610) on the base (2-83) by
inserting the positioning pin on the base into the hole on the printed
circuit board.
o Tighten the screw (2 - 78) to secure the printed circuit board on the
base.
o Place the contact base assembly (2 - 80) on the printed circuit board,
and install the holder (2 - 79) carefully so as not to break the printed
circuit board.
b. E l l - 2 circuit assembly (2-7)
o Install myler sheet (2 -100) on the bottom of the E l l - 2 circuit
assembly (2-7) with adhesive.
o Install the channel plate A (2-8) on the myler sheet (2-100) with
adhesive. Make sure that the channel plate A (2-8) is insulated
with the E l l - 2 circuit assembly (2 - 7).
o Secure the E l l - 2 circuit assembly on the channel plate A with two
screws (2 - 5).
Carefully so as not to break the E l l - 2 circuit assembly (2-7).
c. Connecting connector
o Match the pattern of the E l l - 2 circuit assembly (2 - 7) with that of
the flexible printed circuit board (2 -13).
o Secure them with two screws (2-9) through the rubber cushion (2-11)
and channel plate 6 (2 -10).
Make sure that all the patterns have continuity.
- 9 0 -