FujiFilm FinePix E 500, Руководство по обслуживанию

Страница: 14 / 83

14
2. Disassembly
FinePix E500 Service Manual
1
2
3
J802
CN902
A
B
14+2mm
5mm
2-11. Location of Sheet Parts.
[Attention when Reassemble.]
Do not use removed “Sheet Parts”.
Use surely new parts at the time of reassembly.
2-11-1. UL TAPE1
Paste the UL tape1 to the electrical discharge point of MAIN
PWB ASSY.
* FS00099-100(UL Tape,19mm*0.23mm) is cut in
5 x 14mm and it uses it.
* Put it between CN902 and J801 based on the edge of
MAIN PWB ASSY.
2-10. Removing the BATTRY LID ASSY
(1) Push the LOCK BUTTON.
(2) Open the BATTERY LID in the direction indicated by the
arrow.
(3) Remove the BATT SHAFT.
2-11-
2
. UL TAPE2
Paste the UL tape2 to the electrical discharge point of MAIN
PWB ASSY.
* FS00099-100(UL Tape,19mm*0.23mm) is cut in
5 x 14mm and it uses it.
(A) Pass the wire harness(MIC ASSY) through the space of
the pin of solder part (MAIN PWB ASSY).
(B) Adjust for the tube part of the wire harness(MIC ASSY)
to become under the line.
(C) Paste the UL tape2 to hide the solder part (two places).
(D) Neither "UL tape" nor "Wire harness" must protrude to
this part.
(E) "UL tape" must not protrude to this part(GND PATARN).