FujiFilm BB10768-301(1), Быстрый старт

Страница: 4 / 21

7
Windows
6
Installing the Software
This section describes the setup procedure for using the USB Driver on Windows.
1. Switch on your PC and start up Windows.
(If you are using Windows 2000 Professional, log
on as an Administrator group.)
2. Double-click “My Computer”.
✽
When installation is completed, a new removable disk is added.
3. Insert the enclosed CD-ROM into the CD-ROM
drive.
4. Load a card containing photographed images into
the camera, switch the camera on and set it to
Playback mode.
5. Use the USB cable to connect the camera to the
USB port on the PC.
• Connect the cable to the USB port
on the PC. If the cable is connected
via a USB hub, the software may not
operate correctly. If the PC has 2 or
more USB ports, any USB port can
be used.
• Push the USB connector in fully to
ensure that the connection is
secure. If the cable is not securely
connected, the software will not
operate correctly. Refer to the
Owner’s Manual supplied with the
camera for details.
• To avoid communication errors, use
the USB cable provided in this
package and do not use an
extension cable.
✽
See P.10, if you are using Windows Millennium Edition.
✽
See P.11, if you are using Windows 2000 Professional.
Installing the USB Driver
NOTE
Pre-installation Checklist
Installation on a Windows PC
Hardware and software requirements
To run this software, you must have the hardware and software described below. Check
your system before you begin the installation.
Compatible PCs : IBM PC/AT or compatible
(models with USB support as standard)
Operating System : Windows 98 (including the second edition)
Windows Millennium Edition (Windows Me)
Windows 2000 Professional
(Log on as an Administrator group.)
CPU : 200 MHz Pentium or better
RAM : 32 MB minimum
Hard disk space : Amount required for installation: 60 MB minimum
Amount required for operation: 110 MB minimum
Supported cameras : Fujifilm digital cameras equipped with a USB interface
• Connect the PC and digital camera directly using the USB cable. Connecting
via USB hub is not guaranteed.
• USB interface board is not guaranteed.
• Windows 95 cannot be used.
• Self-made PC is not guaranteed.
• Do not use USB drivers other than the USB Driver provided on the camera
software CD-ROM. You must update your software to the USB Driver provided
on the CD-ROM.
If a noise suppression core is enclosed,
fit the core to the communications cable
to reduce emissions of unwanted
electrical noise. If the cable is already
fitted with a noise suppression core, use
the cable as is.
Noise
suppression core
Press until it clicks shut.
Attach the noise suppression core
NOTE