Fuji Xerox ApeosPort-II C2200, Руководство по эксплуатации функций

Страница: 86 / 137

10 System Settings
84
Sy
st
em
S
e
ttin
gs
10
System Settings Procedure
To make or change the system settings, it is necessary to be in the System
Administration mode.
This section describes the basic procedures for system settings. The following shows
the reference section for each procedure.
Step 1 Entering the System Administration Mode......................................................................84
Step 2 Entering the Administrator ID and Password ..................................................................84
Step 3 Selecting the Operation Mode on the System Administrator Menu ................................85
Step 4 Selecting an Item on the [System Settings] Screen .........................................................85
Step 5 Setting the Feature ...........................................................................................................86
Step 6 Exiting the System Administration Mode........................................................................86
Step 1 Entering the System Administration Mode
Press <Log In/Out> button.
Step 2 Entering the Administrator ID and Password
Enter the Administrator ID for entering the System Administration mode. If you are
using the authentication feature, a password may be required.
It is recommended to change the Administrator ID and password immediately after installing the
machine. For information on the settings, refer to “System Administrator Settings” under “Chapter 10
System Settings” in the User Guide.
1
Enter the Administrator ID with the
numeric keypad or a keyboard
displayed by selecting [Keyboard],
and select [Confirm].
Note • The default Administrator ID is
“11111”. When using the
Authentication feature, a
passcode is required. The
default passcode is “x-admin”.
• If authentication of the system
administrator failed, the
following message appears.
“Login failed. Enter User
Details and select [Confirm].”
• If authentication of the system administrator failed more than preset times, the following
message appears.
“The number of authentication attempted exceeds the maximum. No operation is available.”
1 2 3
4 5 6
7 8 9
0 #
C
<Log In/Out>
button