41
INZ-TN2ZPB-E
$XWRFDOLEUDWLRQVWDWXVFRQWDFWRXWSXWLVFORVHGGXULQJDXWRFDOLEUDWLRQ12VLGHDQGLVRSHQLQRWKHU
cases.
Remote start
:KHWKHUWKHDXWRFDOLEUDWLRQLVVHWDW21RU2))DQDXWRFDOLEUDWLRQLVDYDLODEOHE\UHPRWHVWDUW
LQSXW
Remote start input
Without input
With input (hold at least 1.5 sec.)
Start Time
Cycle
Flow Time
ON/OFF
SUN
1
Zero
Ch1 Span
Ch2 Span
Ch3 Span
Ch4 Span
Ch5 Span
EX. time
ON
12:00
day
350 sec
350 sec
350 sec
350 sec
300 sec
300 sec
300 sec
(An example of “Ch1 through Ch5: enable”, as given in Section 6.2.4 “Auto Calibration
Components/range”)
Flow time
: Auto calibration
Sunday
12:00
Cycle
Zero
calibration
350sec
350sec
ChI
Span
calibration
350sec
Ch2
Span
calibration
Ch3
Span
calibration
Ch4
Span
calibration
Monday
12:00
Tuesday
12:00
Example
In case where auto calibration is carried out at the above setting.
Ch5
Span
calibration
350sec
300sec
300sec
Replace-
ment time
300sec
Cycle
: 1 to 99 hours or 1 to 40 days (initial value 7 days)
Flow time
: 60 to 900 sec
(initial value 300 sec)
Setting range
When an auto calibration starts, the measurement screen appears automatically.
During auto calibration, any key operation is not permitted other than operations such as key lock
ON/OFF and “Forced stop of auto calibration” (see Section 6.4.2.2). When the key lock is set at
ON, even the “Forced stop of auto calibration” cannot be performed. To cancel auto calibration
forcedly, set the key lock to OFF and then execute “Forced stop of auto calibration”.
Turn on the power again after it is turned off (including the case of power failure) at the time set
as the next start time in auto calibration, and then repeat it in the set cycle.
When the hold setting is set to ON, the hold time of auto calibration contact and measurement
value output signal are extended after calibration for gas replacement time.
CAUTION
