User Manual Fugoo Bluetooth Speaker model FSNA1 page 6 9/18/2015
Powering on your Fugoo Bluetooth Speaker
•
Click the (Power) button momentarily to power the speaker on.
• When the speaker runs from battery power, it will power itself off after a period of inactivity,
unless the Power Save feature is Off.
(See the Power Save Mode section for further detail.)
• Hold the (Power) button for one second to
power
the speaker off.
Connecting your speaker to smartphones and other devices
You can connect to your Fugoo speaker to a source device either through its audio input
jack or through a Bluetooth wireless link. Only one of these inputs can be active at a time.
Connecting through an audio cable to the audio input
• Connect one end of the supplied 3.5 mm audio cable to your speaker's audio input
jack, then connect the other end to the headphones jack of your audio source device.
• The LED glows blue and a voice prompt says, “Disconnected. Bluetooth off.
Connected”.
• Plugging the supplied audio cable into the speaker's audio input jack turns off the
Bluetooth wireless link, to save power and maximize battery life.
Pairing and connecting with a Bluetooth source device
1. Make sure that a 3.5 mm audio cable is
not
connected to the speaker's audio input.
2. Place your Fugoo Bluetooth Speaker and your Bluetooth source device within
33 feet (10 meters) of each other.
3. Turn the speaker and the source device on.
4. Hold the
(Bluetooth) button for three seconds. The LED blinks blue and red
repeatedly. If voice prompts are enabled, the speaker says,
“Pairing mode.
Use the Bluetooth settings
of your device to connect.” The speaker will
remain in pairing mode for three minutes, or until it pairs with your device.
5. On your Bluetooth source device, turn Bluetooth on, which will allow it to discover
the speaker. (See the Bluetooth settings information for your device.)
6. Select 'Fugoo Speaker' on your Bluetooth source device.
7. Wait briefly for the speaker to discover your Bluetooth source device. If voice
prompts are enabled, the speaker will say, "Pairing successful
” and “Connected”.
If you hear "Pairing is unsuccessful. Please try again.", try pairing again.
If you are using an iPhone or an iPad that has been previously paired to the
speaker, it may be necessary to 'Forget this Device', as follows:
1. Tap Settings.
2. Tap Bluetooth.
3. Tap the
icon to the right of 'Fugoo Speaker'.
4. Tap 'Forget this Device'.
5. Tap 'Forget Device'.
As long as the speaker is in pairing mode, the iPhone should find the speaker
again, and pair with it.
