20
FT94 TREADMILL
SERVICE CHECKLIST - DIAGNOSIS GUIDE
Before contacting us for aid, please review the following information. It may save you both time and expense. This list
includes common problems that may not be covered under the treadmill’s warranty.
1. Tether cord not in position.
2. Circuit breaker on front grill tripped.
Push circuit breaker in until it locks.
3. Plug is disconnected. Make sure plug is firmly pushed into
115 VAC wall outlet.
4. Breaker panel circuit breaker may be tripped.
5. Treadmill defect. Contact FUEL Fitness.
Display does not light
Tread-belt does not stay centered
Treadmill belt hesitates when
walked/run on
The user may be walking while favoring or putting more weight
on either the left or right foot. If this
walking pattern is natural, track the belt slightly
off-center to the side opposite from the belt
movement. See General Maintenance section on
Tread-belt Tension. Adjust as necessary.
1. If the belt moves, but stops after a short time and the dis-
play shows “E1”, run calibration.
2. If you press Start and the belt never moves, then the display
shows E1, contact service.
Motor is not responsive after press-
ing Start
Treadmill will only achieve
approximately 7 mph but shows higher
speed on display
This indicates motor should be receiving power to
operate. Low AC voltage to treadmill. Do not use an
extension cord. If an extension cord is required it should be as
short as possible and heavy duty 16 gauge minimum. Low volt-
age. vvA minimum of 110 volt AC current is required.
High belt/deck friction. See General Maintenance section on
cleaning the deck. If cleaning doesn’t prevent this from reoccur-
ring, check to see if there is significant wear of the deck. If so, the
deck may need to be flipped if it is on its original side
Tread-belt stops quickly/suddenly when
tether cord is pulled
High belt/deck friction. See General Maintenance. If cleaning
doesn’t prevent this from reoccurring, check the amp draw of
the motor. If this is high and there are signs of significant wear of
the deck, it may need to be flipped if it is on its original side
Treadmill trips on board 15 amp circuit
Treadmill may not be grounded. Static electricity is
“crashing” the computer. Refer to Grounding
Instructions on page 3.
Computer shuts off when console is
touched (on a cold day) while
walking/running
Need to replace the breaker with a “High In-rush
current” type breaker (see page 3 for details)
Circuit breaker trips, but not the
treadmill circuit breaker
Problem
Solution/Cause
Содержание FT94
Страница 25: ......
Страница 26: ...www fuelfitnessusa com 2014 All RIghts Reserved FT94 Owner s Manual ...