Fubag WHS 190 DC, Руководство оператора

Страница: 7 / 27

- - 6
www.fubag.ru
O m perator's anual
Oil
filler
plug
Drain
plug
Positioning the generating set for operation
Place the generating set on a flat, horizontal surface which is firm enough to prevent the set sinking
down (under no circumstances should the set tilt any direction by more than 10°).
Earthing the generating set
Checking the oil level
Checking the fuel level
To earth the generating set, use a 10 mm copper wire attached to the generating set earth
connection and to an earthing rod of galvanised steel set in the ground to a depth of 1 metre. This
also dissipates the static electricity that builds up in the electrical machines.
- Remove the dipstick/plug on the exhaust side
by unscrewing it, and wipe the dipstick.
- Insert the dipstick into the filler neck without
screwing it in. A second plug, without a
dipstick, is available if necessary on the
other side of the engine.
- Check the level and top up if necessary. If it is
necessary:
- Using a funnel, fill the engine oil sump right up
to the top of the filler opening.
- Screw the plug fully back onto the filler tube.
- Check that there are no leaks.
- Wipe off excess oil with a clean cloth.
Check the fuel level and top up if necessary:
-
the fuel tank .
- Fill the tank using a funnel, taking care not to spill petrol.
- Screw the cap back on to the fuel tank.
Only use clean fuel without any water. Do not overfill the tank (there should not be any fuel in the
filler neck). When you have filled up, ensure that the tank cap is closed correctly.
Take care not to spill any fuel when filling the tank.
Before starting up the generating set, and if any fuel has been spilt, make sure that it has dried and
that the vapours have cleared away.
2
See indicator
-20 -10 0 10 20 30
40
-4 14 32 50 68 86 104
5W
10W
20W
# 20
# 30
# 40
10W-30
10W-40
C
F
Ambient
temperature
Single grade
Multigrade