www.fubag.ru
O
m
perator's
anual
3. S
.
.
(
park plug service
4 Fuel sediment cup service TI6000)
To ensure proper engine operation, the spark plug must be properly gapped and free of deposits.
1. Remove the spark plug maintenance cover.
2. Remove the spark plug cap.
3.Clean any dirt from around the spark plug base.
4.Use the wrench to remove the spark plug.
Gasoline is extremely flammable and explosive under certain conditions. Do not smoke or allow
flames or sparks in the area.
The filter prevents dirt or water which may be in the fuel tank from entering the carburetor. If the
engine has not been run for a long time, the filter should be cleaned.
1. Turn the engine switch to the STOP position.
2. Turn the fuel valve lever to the OFF position.
3. Open the left side maintenance cover.
4. Clean the sediment cup in nonflammable or high flash point solvent.
5. Reassemble the sediment cup. Tighten securely.
6. Close and latch the left side maintenance cover.
5. Visually inspect the spark plug. Discard it if the insulator is cracked or chipped. Clean the spark
plug with a wire brush if it is to be reused.
6. Measure the plug gap with a feeler gauge. The gap should be 0 6-0 7 mm. Correct as necessary
by carefully bending the side electrode
7. Install the spark plug carefully, by hand, to avoid cross-threading.
8. After a new spark plug has been seated by hand, it should be tightened 1/2 turn with a wrench to
compress its washer. If a used plug is being reinstalled, it should only require 1/8 to 1/4 turn after
being seated.
9. Reinstall the spark plug cap on the spark plug securely.
10. Reinstall the spark plug maintenance cover.
The spark plug must be securely tightened. An improperly tightened plug
can become very hot and possibly damage the generator.
Never use a spark plug with an improper heat range.
- Never use a spark plug without damping resistance, or it will cause no AC
output.
,
,
.
-
-
- 17 -
Spark plug wrench
Spark plug lover
0,6 - 0,7 мм
CAUTION!
www.fubag.ru
Содержание TI 3000
