700- LT1-SYS-IG Rev 2 22 Oct 2018
Page 20/22
Appendix A
TROUBLESHOOTING
LED Status Indicators:
=
On
=
Off
N/A
–not applicable (can be on, off, or blinking)
=
Blinking once every 10 seconds
= Blinking every second
The following LED patterns indicate Normal Operation:
Indicates Comment
System OK
This is the state when power is first applied once all
connections are made or when initially connecting to
the station using the FTS360 Config App (unit
operating normally, no faults).
Low Power
Mode
Sending a command (such as the connect, add
sensor, or any editing command) will illuminate the
lights as indicated above.
The following LED patterns indicate faults:
Indicates Solution
No power to
the LT1
1) Check battery connections
2) Confirm wire connections to the terminal block
and terminal block firmly seated
Battery fully
discharged
1) Replace battery
2) If being used with a solar panel and regulator,
check connections to ensure battery being charged
or
N/A N/A N/A
SD card not
inserted
Power off the LT1. Insert SD card or confirm inserted
SD card is properly seated and locked.
N/A N/A
CELL:
No cellular
connection
It can take 1-20 minutes (or longer) to get an initial
cellular connection based on numerous factors such
as geographical location, carrier, if the signal has to
roam etc. If after a reasonable time based on the
above factors, the cellular LED is still blinking try the
following:
1) Check Cellular antenna connection
2) Confirm SIM card is inserted correctly
3) SIM card not activated. Call cell plan provider to
activate.
N/A N/A
GOES/
Meteosat:
No
transmission
possible
1) No GPS time fix: Wait for GPS time fix
2) Invalid configuration so transmission not possible.
Review configuration
