FTE MAX S400 HD PLUS, Быстрое руководство по установке

Страница: 29 / 40

PAG.29
rev 1.1
5.9. OTHER
When you select “Other” you will see a screen like OSD 49:
5.9.1. LNB POWER
Here you can set the power output to the LNB. If your receiver
is connected to the LNB directly then you need to set the
LNB Power to “On”. If your receiver is connected to a multi
switch (SMATV signal distribution system) then it may be that
you don’t need to provide the power to the LNB. But since
this is depending on the kind of installed distribution system we
recommend you to contact your installer or to refer to the user
manual of this system to get the correct information.
You also just can change this setting and check if you still can
receive the channels. If the LNB Power is off and you still can
see all channels then we recommend this setting.
5.9.2. CHANNEL PLAY TYPE
In this option you will be able to choose which type of channels
the receiver shown every time it starts. Press [
] in order
to select among All, Free or Scrambled.
5.9.3. CHANNEL CHANGE
From this option you will be able to select the effect that will
be shown in the screen every time you change the channel.
Press [
] in order to select between “Black screen” or
“Freeze” (it will show the frozen image of the cannel you were
watching).
5.9.4. AUTO STANDBY
This option will allow you to activate or deactivate the automatic
Standby option. Options: On, Off.
-On: The receiver will be in standby mode automatically after
3 hours, as long as during this time no commands have been
sent to the receiver through the remote control or buttons of
the front panel, and no programmed timers are run.
-Off: Auto standby function gets deactivated.
Use [
] in order to turn this option on/off.
5.9.5. CLOCK IN STANDBY
If you wish to see the current time in the display while the
receiver is in standby mode, you should confi gure this option
“On”.
SYSTEM SETUP
OSD 49
ENGLISH