CP-100 • User’s Guide
33
3. Installation
Signal Installation
páÖå~ä=fåëí~ää~íáçå
The figure below illustrates a sample CP-100 system. Use this figure for reference during
the signal installation process.
Figure 3-2.
CP-100 System Diagram (sample)
Use the following steps to install signals to/from the CP-100:
1. Input
connections
— any combination of inputs can be connected.
a.
As required, connect analog RGBHV sources to
Inputs 1
through
6
.
Refer to the “
” section on page 34 for a table
of analog input combinations.
b.
As required, connect DVI sources to
Inputs
7
and
8
(using the
connector’s digital pins).
c.
As required, connect analog sources to
Inputs
7
and
8
(using the
connector’s analog pins). A customer-supplied breakout cable or
DVI to
HD-15
adapter is required for this connection.
d.
As required, connect an HD-SDI or SD-SDI source to
Input 9
.
2. Output
connections
— one or both outputs can be connected:
a.
If you connect the CP-100 to a digital projector (for example) or other
target monitoring device, connect the
DVI Output
to the projector’s DVI
input.
b.
If you connect the CP-100 to an analog projector (for example) or other
target monitoring device, connect the
Analog Output
(HD-15) to the
projector’s analog input.
CP-100
Inputs 1 - 6 (Analog)
Inputs 7 - 8 (DVI)
Input 9 (HD/SD SDI)
Sample Source Input
Devices
DVI
Analog
Ethernet
Serial
Содержание Compass Plus CP-100
Страница 1: ...rëÉêÛë dìáÇÉ CP 100 43926 LIT1228B TM ...
Страница 20: ...20 CP 100 User s Guide NK fåíêçÇìÅíáçå Application Questions ...
Страница 100: ...100 CP 100 User s Guide 4 Operation Understanding Front Panel Lockout ...
Страница 122: ...122 CP 100 User s Guide K péÉÅáÑáÅ íáçåë Format Table ...
